how to install yak gear deluxe anchor trolley

Tension the cord so it runs high along the side of the cockpit and lock in place by tying a series of four half-hitch knots.I am using the Yak-Gear AK1 Deluxe Anchor Trolley Kit, and I have had several exciting experiences with it.

Thread the stainless clip through the loop at the end of the cord. I fish in a river with my kayak, and I think an anchor trolley is a must-have because, without this set-up, I would be constantly irritated with position movement and bad angles to cast.Run the cord end with the loop up through one pulley and down through the other.Attach the pulleys to your kayak using the stainless saddles and screws.Well Nuts are self-sealing rubber nuts that fit pre-drilled 10mm holes. *If your kayak doesn't have inserts fitted, ask for 'well nuts' to be supplied. The Running Rig comes standard with saddles and screws to fit the brass inserts that may be moulded into your kayak. This is a must for the serious kayak fisherman.Ī Running Rig is used in conjunction with an anchor or Drift Chute (Drogue) and can be set off the front or the rear of the kayak simply by pulling the cord through the pulleys. Made with Stainless Steel fittings and using Spectra Cord (a non-stretch cord). For installation of the pad eyes, simply use technique above with the self-tapping screws. Hardware Change for 2016 - The kit now comes with 6 stainless self-tapping screws (2 for the cleat and 4 for the pad eyes) as a replacement to the rivets for the pad eyes. Adjustable Multi-Fit Kayak Running Rig (Anchor Trolley). How to Install a YakGear Kayak Anchor Trolley.

How to install yak gear deluxe anchor trolley